7
MAINTENANCE AND CLEANING
Automatic Defrosting of the Appliance
There is no need to defrost the chiller, because ice depositing on the inner back wall is
defrosted
automatically.
Ice build-up on the inner back wall during the compressor operation will defrost
automatically (when the compressor has cycled off).
Defrost water will drain out passing through the drain outlet in the inner back wall into a
drain pan situated above the compressor, from where it evaporates.
Cleaning the Appliance
Disconnect the power supply before cleaning the appliance.
Do not use coarse or aggressive cleaning agents as you may damage the surface.
Clean the exterior with moist cloth.
Remove the detachable accessories in the interior of the appliance and clean the shelves
with water and liquid detergent. Plastic parts cannot be washed in dishwashers.
Clean the interior of the appliance, except for the lamp holder and lamp with moist cloth,
adding one or two drops of vinegar.
After cleaning, connect the appliance to power supply and reload it.
Switch Off the Appliance When Not In Use
If you do not intend to use the appliance for long periods of time, disconnect the power
supply, take out the contents and defrost and clean the appliance. Leave the door slightly
open.
TROUBLE-SHOOTING GUIDE
Sometimes you may come across minor problems that in most cases do not require a
service call and can be easily eliminated. The problem may have resulted from improper
handling and / or installation of the appliance. Please refer to the below trouble-shooting
guide to assist you in identifying the possible cause and solution to your problem. Should
the problem still persist after completing these checkpoints, contact the closest authorized
service agent in your area for assistance.
The Appliance Fail to operate after Connecting to Electrical Power Supply
Make sure the power cord is properly connected.
Check the power supply in the electrical outlet. (Whether the fuse or circuit breaker was
broken or not).
Make sure the appliance is switched on. (e.g. thermostat knob in operating position)
Continuous Operation of the Cooling System
The door is frequently opened or left open for too long.
The door is not properly closed (the door may sag; the gasket may be polluted or
damaged). Perhaps you have overloaded the appliance.
Summary of Contents for CCFW WC 309 SWD
Page 21: ...10 ...
