Thank you for purchasing this Softener. We are sure that it will
provide you with trouble free service for many years to come. Please
use the following pages to assist you in the installation and set up of
your new Softener.
Identifying your Softener
Your softener will have a identification label fixed to the outer carton and
the control valve, this will look similar to the picture shown here.
The information listed can be read as follows:
4202035013
SNo
08090137 Mis
0919-255-760
Stock Number:
Manufacturers part number.
Serial No:
Serial No.
Id Code:
Softener type identification code.
Configuration:
Vessel size, Valve type & Controller type.
Identify the settings relevant to your softener from the chart below by looking at
the vessel size and controller type.
General Information
Valve connections.
255 Valve Inlet ¾”
Outlet ¾”
Drain ½” Barbed, Overflow ½” Barbed
268 Valve Inlet 1”
Outlet 1”
Drain ¾” Barbed, Overflow ½” Barbed
Power requirement
240V
(12V, 50Hz, 3 amp plug in transformer supplied).
Inlet water pressure
Min 20 psi, Max 120psi
Working temperature
Max 40° C, Protect from frost
The softener may or may not be supplied with connection hoses, drain hoses
or bypass valve sets depending on your supplier; these are available to order
separately if required from your supplier.
Planning Your Installation.
Please observe the regulations concerning the installation of your water
softener. For guidance check out the water regulations advisory service web site
(www.wras.co.uk) Check that you only have one rising main, that you have
allowed space for access to the unit for possible future maintenance and salt
replenishment. Check the water pressure; locate the rising main (stop cock) a
drain facility and a power supply.
Unless you are replacing an existing water softener, this installation will
require you to carry out plumbing work and may require an electrical outlet to
be fitted near the softener, this should be carried out by a qualified person.
