Tools required
Install the
leg base
to the
table top assembly
by
aligning and inserting each tenon on the leg base into
the cutout on the table top assembly
. Then slide a
¼” –
20 x
50mm hex bolt into each hole and tighten with the
provided Allen wrench to secure the
leg base
assembly
to the
table top assembly
(
Figure 2
).
Step 2:
Install the
table leg sub-assembly
Allen wrench
Figure 2
.
Install the
leg assembly
to
2
Table top
assembly
the
table top assembly
Lockup handle
¼” – 20 x
50mm hex bolt
Leg Base
Cutout
Attention
After the table is fully assembled, DO NOT try to pick up the table from the ends
–
especially if the table is fully extended. Should the table need to be relocated, close the
table and carefully lift the table in the middle area where the two tops meet.
