Tools required
Insert
¼” – 20 x 50mm hex bolts in each
of the eight corner locations (
Figure 4,
arrows
). Do not fully tighten bolts.
It is
CRITICALLY IMPORTANT that the
50MM
HEX
BOLTS
are
properly
seated
in
the
EIGHT
locations
illustrated in Figure 4. Inserting the
incorrect bolts or not installing any
bolts
into
these
locations
could
result in product FAILURE.
Step 4:
Insert the 50mm hex bolts
Allen wrench
Figure 6
.
Tighten all 36 hex bolts
3
FTBD deck
¼” - 20 x 50mm
hex bolts
in corner locations
Figure 4
.
Insert 50mm hex bolts
in 28 remaining locations
Figure 5
.
Insert 35mm hex bolts
HDBD deck
If you ordered Astrid bed without the headboard, your bed is fully assembled.
The following steps are for the bed with headboard(s)
Insert the 28 remaining
¼” – 20 x 35mm
hex bolts in the remaining locations on
the decks (
Figure 5, squares with
hidden lines
). Again, do not fully tighten.
After all bolts have been inserted, use
the Allen wrench to fully tighten all 36
bolts (
Figure 6
).
Step 5:
Insert the 35mm hex bolts
¼” - 20 x 35mm
hex bolts
¼” - 20 x 35mm
hex bolts