5
class; the range of the dwelling time is
：
1 to 255.
◆
When the No. N preset point is set as No. 0, then all preset points before the No. N preset point in the track
will be valid however all numbers of preset points afterward and their speed and dwelling time shall be set as
0 automatically.
◆
After tracks are edited, press OFF to store and exit while push the joystick to exit without storage.
6. Run Cruise Track:
[SHOT]+[N]+ [Enter]
Display
：
Input Tour No
：
01
Description
：
N
––
No. of the track from 1 to 6.
Function
：
Tour the No. N track and stop tour by pushing the joystick.
7. Stop Cruise Track:
[SHOT]+[N]+ [OFF]
Display
：
Input Tour No
：
01
Description
：
N
––
No. of the track from 1 to 6.
Function
：
Stop the No. N track or stop tour by pushing the joystick.
8. Cancel Cruise Track:
[SHOT]+[N]+ [OFF] (Pressing [OFF] down until
“
Clear Tour OK
”
appears)
Display
：
Input Tour No
：
01
Description
：
N
––
No. of the track from 1 to 6.
Function
：
Delete the No. N track
9. Auto Pan ON (Operation of COP-2 Protocol):
[AUTO]+[P1]+[ON]+[P2]+[OFF]
Display
：
Input 1st No
：
001
Description
：
P1
––––
the starting scan No. of preset point from 1 to 255, which should be set already.
Display
：
Input 2nd No
：
002
Description
：
P2
––––
the ending scan No. of preset point from 1 to 255, which should be set already.
If P1 = P2 or P1 and P2 are coincided, the speed dome will make scan in range of 360
°
.
Note:
(1) For PELCO-D and PELCO-P Protocols the way of operation is as follows:
◆
Set the Starting Scan Position: Transfer the speed dome to the starting scan position, operation
[AUTO]+[ON]
◆
Set the Ending Scan Position: Transfer the speed dome to the ending scan position, operation
[AUTO]+[OFF]
◆
Run Auto Pan
：
[AUTO]+[ENTER]
(2) Auto Pan operation takes the following parameters. You must set these parameters before using a
Auto Pan command to begin the scan operation. You can use the scan Stop command or PT scan stop
command to stop the scan. Setting scan condition:
◆
Auto Pan Position(First specify position, second specify position)
◆
Auto Pan Speed and Direction.
10. Stop Auto Pan
：
[AUTO]+[OFF]
(only for
COP-2
protocol)or push the joystick to stop scan.
