Section 5
11
Menu Function
5
RS232
The RS232 output was intended for data-logging and third-party monitoring, but is no longer
supported by CSI. The steps below are provided for reference only.
Follow these steps to navigate in the RS232 option.
Action
Key
Display
Press and hold UP+DOWN key for 3 seconds to
enter the menu.
The option “UNIT” will appear in the display
Press DOWN key until the option “RS232” appears
in the display
Press and hold set-point key to change values.
While holding the set-point key in, press either the
arrow UP or arrow DOWN key to select between
“ON” and “OFF”.
“OFF”: The RS232 function is turned off.
“ON”: Data is send once every two seconds.
When the required setting is activated, let go of the
set-point key
Press and hold UP+DOWN key for 3 seconds to exit
the menu.
Note: Connect the RS232 cable before start.
r 2 3 2
