background image

CHARGING INSTRUCTIONS: 

There are 5 LED on the main unit, the first three
LEDs show the power capacity of the mower
during operation. When the first 3 LEDs turn off
and the fourth LED becomes fainter, you are
being reminded that the mower needs to be
charged. The last LED is the charging indicator.

NOTES:

• To keep the battery in prime condition it is

best to charge the battery after each use, and
every 3 months if stored without use. After
each use charge for 24 hours to ensure the
battery is fully charged. 

IMPORTANT: Charge the battery after
each use. Never store the unit with a flat
battery.

• The battery will not be damaged if it is

charged for longer than 24 hours, but it is
advisable not to leave it on for more than 48
hours, since this might shorten the battery life.

• Ensure the battery is fitted and locked

correctly before mowing, or else, this product
will not work and be damaged.

• Only use the charger supplied with this

product. Do not attempt to charge this
product with any other charger nor attempt to
charge any product with this charger, as it can
cause damage and will invalidate your
guarantee. 

BATTERY CHARGING AND RECHARGING

Before first use charge the battery for 24 hours.

Warning: if the battery is damaged
in any way do not attempt to charge
it, and replace it immediately.

The battery does not have to be removed
from the mower to be charged. 

To charge the battery in the mower, plug
the charger into the battery socket.

Plug the charger adaptor into a suitable electrical socket.

Once the battery is fully charged remove the charger connector from the battery
and unplug the charger adaptor from the mains socket. Do not pull the charger
by the cord.

Charging battery out of mower

First turn the knob on the battery lid anti-clockwise, then raise the handle and lift
battery out of the mower. Place the battery on a dry, flat and non-slip surface,
and plug the charger connector into the battery socket. Charge the battery for 24
hours each time. Red LED light indicates that battery is charging, but will NOT
turn off once battery is fully charged.

Charging battery in mower

Lower it into the cavity on the top of the unit in the correct orientation. Ensure
the handle is pressed down and then turn the knob on the lid clockwise. If the
battery does not fit correctly, remove it and check there are no obstructions.
Ensure that the machine is SWITCHED OFF when recharging battery. As a safety
feature the battery will NOT recharge if the machine is switched on. The Red LED
light on the Main unit indicates that the battery is charging, but will NOT turn off
once battery is fully charged.

Charging the battery in the mower

Charging battery out of the mower

Red LED means charging

Summary of Contents for Victor Garden Tools 9806









Reviews: