Electric Coffee Percolator
9667
Instructions for Use
Please read and retain these instructions for future reference
v004: 17/10/17
WARNING
CHECK ALL PARTS FOR DAMAGE BEFORE USE. DO NOT USE IF DAMAGED IN ANY WAY.
CHECK THE VOLTAGE SHOWN ON THE UNIT MATCHES THE MAINS VOLTAGE IN YOUR HOME.
DO NOT TOUCH HOT SURFACES SUCH AS THE STAINLESS STEEL PARTS OF THE PERCOLATOR.
ALWAYS USE THE HANDLES AND KNOBS.
ALWAYS SWITCH OFF AND UNPLUG FROM THE MAINS WHEN NOT IN USE. UNPLUG BY PULLING THE
PLUG ITSELF. DO NOT PULL ON THE POWER CABLE.
DO NOT IMMERSE THE BASE OR POWER CABLE IN WATER OR ANY OTHER LIQUID.
KEEP AWAY FROM CHILDREN.
FOR INDOOR, DOMESTIC USE ONLY.
KEEP AWAY FROM HEAT SOURCES.
DO NOT ALLOW THE POWER CABLE TO HANG OVER THE EDGE OF THE WORK SURFACE OR TO TOUCH
HOT SURFACES.
ALWAYS FILL WATER ABOVE THE MINIMUM LEVEL AND BELOW THE MAXIMUM LEVEL.
DO NOT OPERATE WHEN WATER IS BELOW THE MINIMUM LEVEL.
ALWAYS FILL THE PERCOLATOR JUG WITH WATER AND PLACE ONTO THE BASE BEFORE PLUGGING IN
AND SWITCHING ON.
DO NOT REMOVE THE LID DURING THE BREWING CYCLE AS HOT STEAM MAY SCALD.
ALWAYS ENSURE THE LID IS SECURE BEFORE SERVING.
THIS UNIT SHOULD NOT BE USED BY PERSONS (INCLUDING CHILDREN) WITH REDUCED PHYSICAL,
SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE
BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY A PERSON
RESPONSIBLE FOR THEIR SAFETY.
PLUG WIRING (UK & IRELAND)
This appliance is fitted with a BS 1363 13-amp plug. If you have to replace the fuse, only those that are ASTA or
BSI approved to BS1362 and with a rated current of 13-amps should be used. If there is a fuse cover fitted, this
cover must be re-fitted after changing the fuse. If the fuse cover is lost or damaged the plug must not be used.
Spare fuse holders and fuses are available from electrical outlets. If the socket outlets in your home or office
are not suitable for this product’s plug, the plug must be removed and disposed of safely. Attempts to insert
the plug into the wrong socket is likely to cause electric hazard. A replacement plug should be wired according
to the following instructions:
The cable
A mains electricity cable contains two or three inner wires. Each has a core of copper and an outer layer of
flexible plastic. This product is earthed; the wires in the cord set are colour coded in the following way:
BLUE NEUTRAL
BROWN LIVE
GREEN & YELLOW EARTH
The diagram below shows the key features of a correctly wired three-pin mains plug.
Note:
Double insulated appliances do not need
the green & yellow Earth wire. They may
only have the Brown and Blue wires.
