OPERATION:
• Place the sharpener on a
flat, sturdy surface and plug
into mains.
• Select a clean drill bit to be
sharpened and match its size
with one of the holes in the
head of the sharpener.
• Put the bit into the
appropriate hole and turn the
unit on (1)
• Exert a slight downward
pressure onto the drill bit and
rotate the bit back and forth
for about 20 seconds while
sharpening.
• Depending on the drill bit
being used you may need to
adjust the height of the
grinding wheel using the
turning knob (2). Turn the
adjusting knob clockwise to
raise the wheel. This will give
you an aggressive cutting
action. This is also useful
when you are working with
short drill bits. Turn the
adjusting knob anti-clockwise
if you want a finer ground
edge. This process will take
longer and may require more
repetitions. This is useful
however when working with
longer drill bits.
• Turn unit off and examine the bit in accordance with the ‘Sharpening
Troubleshooting’ section.
• Repeat the above steps to the other side of the bit. Sharpen both sides of the
drill bit for the same amount of time using the same amount of pressure.
• Repeat the above steps as necessary to sharpen the bit.
SHARPENING TROUBLESHOOTING:
• If the tip of the drill bit turns blue, it is overheating.
Reduce the amount of pressure and sharpening
time. Cool the drill bit in water, before continuing
make sure bit is dry.
• If one edge is longer than the other, and the point is
not centred, sharpen the shorter side for a little
longer. To prevent this from happening sharpen both
sides the same amount of time applying the same
amount of pressure.
DISPOSAL
• Dispose of all paper, cartons and plastic in
accordance with your local recycling regulations. At
the end of the product’s lifespan please dispose of it
at an authorised household waste recycling centre.
EC DECLARATION OF CONFORMITY
We The Enterprise Department Ltd t/a Coopers of
Stortford of 11 Bridge Street, Bishop’s Stortford,
Hertfordshire, UK. CM23 2JU in accordance with the
following Directive(s):
EMC Directive (2004/108/EC)
EN55014-1:2006/+A1:2009
EN55014-2:1997/+A1:2001/+A2:2008
EN61000-3-2:2006/+A1:2009/+A2:2009
EN61000-3-3:2008
hereby declare that:
Electric Drill Sharpener
has been designed to comply with the relevant
sections of the above referenced specifications. The
unit complies with all applicable Essential
Requirements of the Directives.
Mr. Stuart Fowler
Imports Director
1.
Rotate back
and forth
about 20˚
2.
