8
Correct
Incorrect
Sweep slowly. Hurrying will cause you to miss targets.
It is better you sweep the search coil from side to side in an arc line of 7.5cm (3 inches) motion and keep the search
coil parallel with the ground.
If the detector detects the item, it sounds a tone. An arrow and the depth appear on the display below the target
icon. If the detector does not detect the item, make sure that the target mode is set correctly for the type of metal
you’re searching for. Also make sure that you’re moving the search coil correctly.
Notes:
The detector responds with a signal when it detects most valuable metal objects. If a signal does not repeat
after you sweep the search coil over the target a few times, the target is probably scrap metal.
False signals can be caused by litter-strewn ground, electrical interference, or a large irregular-shaped piece of
scrap metal.
False signals are usually broken or intermittent.
Adjusting SENSITIVITY
After you become familiar with how your detector works, it’s important to fine tune the sensitivity to get the best
performance. Press the button SENS button on the panel. Then press UP or DN key to increase or decrease the
sensitivity. The level on the segment will be displayed from high to low position.
Note:
In order to detect the target deeply buried, you can adjust the SENS to a higher position. Setting the level of SENS
to Max position, may cause the detector to receive interference and false signals from broadcast antenna and other
electronic lines. The detector may have unstable arrow and irregular tone indications.
Application Hints
Pinpointing the Target
Accurately pinpointing a target makes digging it up easier. But this takes practice. We suggest you practice finding
sample on your own property before you search in other locations.
