4L Instant Water Boiler
10377
Instructions for Use
Please read and retain these instructions for future reference
v008:02/01/19
Page No. 3
2.
HOW TO USE
If using the appliance for first time, please clean and rinse the water tank before use.
Setup:
Place a receptacle onto the tray.
Press the Lock button for approximately 3 to 5 second to open.
Press the Temp button and select 000 degree setting
Press the Volume button and select 000 volume setting
After dispensing a quantity of normal temperature water, please press Temp button to 100 degree
setting and Volume to 000 volume setting to operate the appliance for 1 minute until the
detection of boiling point is finished and the unit functions.
Note: This procedure will need to be repeated after the appliance has been unplugged.
Fill with water
Open the lid, fill the water tank with the desired amount of water, and then close the lid.
Note: the water level must be below the Max level.
Tips: Use filtered water in the appliance.
Obtain desired water
Make sure the plug is connected to the mains wall outlet, and the water tank is filled with the
desired
amount of water.
Place your cup on the removable water tray, make sure it aligns with the spout.
First press the
Lock
button about 3-5 seconds to open.
Temp.
and
Volume
setting indicator light up.
Press the
Temp.
button to choose your desired temperature and press the
Volume
button to set
right
water volume. Press the
Confirm
button to operate the appliance. Water will flow out
continuously from water spout after 5-10s.
When you have obtained the desired amount of water, press the Confirm button to stop the
appliance. Please note that this may take a few seconds so please take care not to overfill.
As ambient temperature can change every day, the water volume dispensed can fluctuate within
-15% to +15%.
CAUTION! Always watch the filling of your cup or mug and press the confirm button to stop the
water dispensing before it reaches the rim to avoid overfilling and spillage of hot water.
