2.5L Water Boiler w/Light G051
Instructions for Use
Please read and retain these instructions for future reference v001: 18/06/19
Page No. 3
2. Dispense water:
Make sure the plug is connected to the proper mains socket, and fill water tank with water. Place
your cup on the removable water tray. Make sure the cup is aligned with the spout. Press the
ON/OFF button once and the indicator on top turns on blue and the indicator light next to the spout
also turns blue. After about 5-10 seconds it starts to dispense 200ml hot water. When the cup is full
both lights go out.
Press the ON/OFF button twice and the indicator light on top turns green and also the indicator
light beside the spout turns on green. After about 5-8s, hot water is dispensed in continuous flow.
When you have obtained your desired amount of water, press the button again and the appliance
stops working at once.
If there is not enough water in the water tank, the blue light and the green light will flash
alternately.
To obtain hot water again, repeat the above procedure.
Caution:
In the event of the ON/OFF switch malfunctioning and preventing water flow from stopping, stop
using this immediately.
Switch off from the mains plug socket and unplug immediately.
Remarks:
Do not touch the boiled water and steam to avoid risk of scalding.
The appliance has a manual thermostat to reset
the heating function. If the unit has no power, has
stopped working or does not dispense boiling
water, you can reset the thermostat by pressing
the reset button.
3. Water disposal from the water tray
When the water tray is full, stabilize the appliance with one hand and grasp the water tray. Use the
other hand to lift up the water tray slightly to remove it. Empty the water tray and insert it into the
original place with proper force.