Mini Heater
F883
Instructions for Use
Please read and retain these instructions for future reference
v001: 07/05/19
above, this is generally caused by (partially) covering the heater or obstructing the air intake and/or
outlet grills or installing the heater too close to a wall or something similar. When the overheating
safeguard switches the heater off, you need to turn the switch to the ”O position” (off) and remove
the heater from the socket. Allow the heater to cool down and make sure what caused the
overheating is removed or amended. The heater can then be reused. If the problem persists or if you
cannot find an obvious cause of overheating, turn the heater off immediately and take the plug out
of the socket.
SET-UP AND OPERATION:
Make sure that the heater is switched to the off position (O) then plug into a correctly
functioning 220-240V/50HZ socket.
Now set the main switch to the on position (I); the heater is now on standby and the indicator
light(7) lights up.
Switch on the heater by pressing the
on/standby button (12) .
After switching on by means of the main switch, the thermostat is on the maximum 30
℃
. Press
the “Temp-” button to set the desired temperature (minimum 15
℃
).Press the “Temp+” button
to increase the temperature. The display shows the set temperature.
The thermostat will now regulate the heater to turn on if the temperature is too low and off
once the desired temperature is reached.
-
Press “Temp+” and “Temp-” at the same time to speed up the fan or to slow it down. The display
shows the setting for a moment flashing LL=low or HH=high.
Press the timer button to set the timer. The display changes from degrees to hours. Hold in the
button to increase the number of hours, up to a maximum of 12.
If you set the timer while the heater is on, you set the number of hours after which the heater
turns itself off.
To switch off the heater you must first set it to standby by pressing the ON/standby button. The
heater will stop heating, but the fan cools for another 60 seconds (see display) before switching
off. You can then use the main switch to turn off the heater properly (O pressed). Never leave
the plug in the socket when the heater is not in use.
This product is only suitable for well insulated spaces or occasional use.
SAFETY INSTRUCTIONS:
WHEN USING ELECTRICAL APPLIANCES, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED:
READ ALL INSTRUCTIONS BEFORE USE.
TO PROTECT AGAINST ELECTRIC SHOCK, DO NOT IMMERSE PLUG OR APPLIANCE, IN WATER
OR ANY OTHER LIQUID.
UNPLUG FROM OUTLET WHEN NOT IN USE AND BEFORE CLEANING.
