Cleaning
Do not clean the appliance or any parts in water or in
the dishwater.
1. Disconnect the appliance from the power before you
cleaning.
2. Clean the appliance and parts with a damp cloth or
soft brush.
3. Use a small pair of scissors to cut away hairs or
thread from the roller brushes.
Emptying the dust container
1. Empty the dust container after each use.
2. Place the handle in the upright position.
3. Press the dust container release button and lift the
dust container out of the sweeper base.
4. Hold dust container over the rubbish bin , then press
the release button on the lower handle downwards to
open the dust container door and empty.
5. Place the dust container back into the sweeper base
and push it down into position.
6. The dust container door closes automatically when
you put the dust container back into the sweeper base.
Cleaning the roller brush
1. Switch off the appliance before you clean the roller
brush.
2. Use a pair of scissors to cut the hairs, threads etc.
that have collected around the roller brush.
3. Remove fluff, hairs and other dirt from the roller
brush.
Note:
if you are unable to clean the roller brush
properly in this way, you can remove it for more
thorough cleaning. See sections removing the roller
brush and reinserting the roller brush.
Removing the roller brush
1. To remove the handle, press the release button on the
lower handle and pull the handle upwards.
2. Turn the sweeper base upside down, push the
retainer release button and remove the retainer.
3. Slip the belt off the end of roller brush and lift the
roller brush out of the base.
4. Remove fluff, hairs and other dirt from the roller
brush.
Reinserting the roller brush
1. Slip the belt over the ribbed end of the roller brush.
Insert the other end of the roller brush into the slot
opposite the belt.
2. Insert the end of the roller brush with the belt into
the other slot. Don’t force the roller brush into the
slot. Rotate the roller brush so that the ridge on the
side with the belt points upwards.
3. Put the retainer back into the slot and slide the
release slide to its original position.
If the roller brush is not properly inserted, you
can’t move the release slide to locked position.
Check carefully before use.
PACKAGING:
• Dispose of the packaging at your local recycling centre.
• Dispose of paper and carton separately from plastic bags at your local recycling
centre.
• Dispose of the item at the end of its lifespan at your local authorised
household waste recycling centre.
Troubleshooting
Problem
Possible cause
Solution
The appliance doesn’t work
You have not charged the appliance sufficiently
Charge the appliance
The appliance doesn’t charge
You have not inserted the adaptor properly
Check the connections
into the mains power or the appliance
The appliance is not switched off properly
Make sure on/off switch is in off position
The appliance doesn’t pick up dirt effectively
The dust container is full
Empty the dust container
The roller brush is clogged
Clean the roller brush
Dirt escapes from the appliance
Dust container is full
Empty the dust container
Dust container door is not closed properly
Make sure you have placed the dust container
correctly into the base
The appliance becomes noisy during operation
Dirt has accumulated around the roller
Clean the roller brush and the belt
brush and the belt
The appliance has a short operating time
You have not charged the battery
Discharge the battery completely, let the appliance
in the optimal way
run until it stops, then recharge the battery for
10-12 hours. Repeat this discharge-charge cycle a
few times