Patio Heater
10252
Instructions
v1.0: 10/11/15
Assembly:
Insert lower tube (8) through the hole of base cover (9) and (10) with the welded disc facing
downwards and the locating tongue in its seat in the base. Secure with washer (11) and L screw (12).
Connect mid tube (7) to the lower tube (8) and secure with two screws (6). Insert straight tube (3)
upwards inside of upper tube (5).
Screw outer fastener (4) on to upper tube (5).Then pull straight tube (3) upward from the inside of
upper tube (5). Then install upper tube (5) on mid tube (7). Secure with two screws (6).
Insert end of straight tube (3) into the hole on bottom of control box (1). Secure with screw (6).
Turn outer fastener (4) counter clockwise and adjust the unit to a desired height. Then fasten
clockwise.
Clip power supply cord with cord clips (13).
The head of the heater is adjustable up to 25 degrees. Adjust to desired angle.
Use:
Connect the mains cable to a suitable power socket.
Pull the control pull repeatedly to cycle through the following heat settings:
0 = Off
L = Low
M = Medium
H = High
