15
HOW TO USE THE SOLDERING TIP
Be sure the hot air exhaust opening is
positioned upward, as illustrated. Keep
hands and combustibles clear of exhaust
opening to avoid burns or fire.
Push ignition button slowly and hold
three seconds after it clicks.
Adjust tip temperatur with gas control
lever.
Loosen knurled nut to remove tip and tip
housing being careful not to cut piezo
wiring.
HOW TO USE THE HOT BLOW NOZZLE
Set control lever to "3". Set gas ON/OFF
lever to "ON" position. In cold tempera-
tures or immediately after gas filling set
lever higher than "3".
Wait until the window becomes red,
then release button slowly. If it fails to
ignite, repeat ignition process outlined
under stip 3 above.
To turn off, slide the gas ON/OFF lever to
"OFF" position until it clicks. (Control
lever does not turn off).
Replace with hot blow nozzle. Ignition is
the same as for soldering.
1.
2.
3.
4.
5.
6.
1.
2.