P84249 F
Sheet 2 of 4
FEATURES
:
-
Available in five colors: Red, Green, Yellow, White
or Blue
-
Custom wording available
-
Polycarbonate faceplate
-
Stainless steel backplate
-
UL 2017 listed switch assembly
-
ADA Compliant
-
Mounts to single-gang electrical backbox.
-
Interchangeable or replaceable Normally Open (NO)
and Normally Closed (NC) single pole, single throw
gold plated contact blocks rated for 3 amps @ 600
VAC or 1 amp @ 250 VDC.
-
Can be reset by depressing the "Push" button, and
turning clockwise a 1/4 turn.
-
Measurements: 5" H x 3-1/4" W x 1-1/2" D.
MOUNTING INSTRUCTIONS:
STATION LABEL
MOUNTING SCREW
(SUPPLIED)
PUSH/TURN
RESET BUTTON
STATION HOUSING
GREEN, YELLOW, WHITE,
BLUE OR RED
BACKPLATE ASSEMBLY
WHEELOCK RECOMMENDS THE USE OF THIS
SPACER (NOT PROVIDED) FOR SWITCH CLEARANCE
ON STANDARD SINGLE GANG BOXES
(2) 6-32 X 1" SCREWS
(SUPPLIED)
Figure 2: Overview of Assembly
SEPARATION OF TERMINAL ASSEMBLY.
FROM BUTTON ASSEMBLY IS AS
FOLLOWS.
GRASP TERMINAL HOUSING AND
USING THUMB APPLY PRESSURE
DOWNWARD.
REMOVE TERMINAL.
REMOVAL OF TERMINAL BLOCK
FROM TERMINAL HOUSING.
INSERT SMALL SCREWDRIVER
AS SHOWN AND PRY
UPWARD, REMOVE TERMINAL.
.
Figure 3: Back view of Push Station
NOTE:
To provide adequate clearance for installation, one of the following is recommended: System Tech. Inc. (STI) #102722
Spacer, or Raco #660 W/1/2" K.O. and Raco #653 Extension Ring. Also Raco #696 Masonry Box.
NOTE:
Additional Normally Open, NPS-NO (0523) or Normally Closed, NPS-NC (0524) can be purchased separately.
