MOUNTING INSTRUCTIONS: (SP40S)
Figure 2 shows the mounting location of the SP4Z-A/B Splitter to the SP40S panel. Figure 3 shows the correct mounting procedure.
SP4Z-A/B
MOUNTING STUDS
Figure 2:
Mounting Location
SP4Z-A/B STANDOFFS(4)
SP4Z-A/B PC BOARD
COVER STANDOFFS (4)
SP4Z-A/B COVER
MOUNTING SCREW (4)
TOP
RIGHT
SIDE
SP40S PC BOARD
SP40S ENCLOSURE
Figure 3:
SP4Z-A/B Mounting in SP40S Enclosure
1.
Install 4 standoffs through the SP40s board to the 4 mounting studs of the SP40S enclosure.
2.
Position the SP4Z-A/B PC board with the terminal blocks pointing to the top of the SP40S enclosure and align the mounting holes on the PC board with the
mounting studs.
3.
Screw the male end of the 4 cover standoffs through the SP4Z-A/B PC board and to the 4 standoff installed in Step 1. Tighten standoffs snug.
4.
Attach wiring in accordance with the wiring section of this installation instruction.
5.
Align the SP4Z-A/B cover with the holes in the cover standoffs and mount the cover using the 4 mounting screws. Tighten the screws hand tight.
P84205 Rev. P
Sheet 2 of 9
