273 Branchport Avenue
Long Branch, N.J. 07740
(800) 631-2148
Thank you for using our products.
www.cooperwheelock.com
INSTALLATION INSTRUCTIONS
CLASS A/B SPLITTER
(FOR SP40S AND SPB-160/SPB-80/4)
Use this product according to this instruction manual. Please keep this instruction manual for future reference.
MODEL NUMBER:
109900
SP4Z-A/B
GENERAL:
The Class A/B Splitter (SP4Z-A/B) is designed to be used with Wheelock’s SP40S SAFEPATH4 panel and the SAFEPATH4 Audio Booster (SPB-160 and SPB-80/4)
panels. The SP4Z-A/B provides a means for expanding one supervised audio output zone to four Class B or two Class A zones.
The SP4Z-A/B is UL Listed under
Standard 864
, Control Units for Fire Protective Signaling Systems. They are for indoor use only.
One SP4Z-A/B can be connected to the SP40S panel. It is to be mounted inside the panel enclosure onto the standoffs on the SP40S board. Two SP4Z-A/B's can be
connected to the SPB-160. One SP4Z-A/B can be connected to the SPB-80/4. It is to be mounted inside the SPB-160 or SPB-80/4 panel on the Splitter Mounting
Bracket (SPMB-4Z - purchased separately) mounted over the 24VDC Power Supply (SPBPS). The SP4Z-A/B has a maximum power output per zone that cannot exceed
what is listed in Table 1.
NOTE:
All
CAUTIONS
and
WARNINGS
are identified by the symbol
. All warnings are printed in bold capital letters.
WARNING: PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT. FAILURE TO COMPLY WITH ANY OF
THE FOLLOWING INSTRUCTIONS, CAUTIONS AND WARNINGS COULD RESULT IN IMPROPER APPLICATION, INSTALLATION AND/OR
OPERATION OF THESE PRODUCTS IN AN EMERGENCY SITUATION, WHICH COULD RESULT IN PROPERTY DAMAGE AND SERIOUS INJURY
OR DEATH TO YOU AND/OR OTHERS.
SPECIFICATIONS:
Table 1: Specifications
Audio Output Voltage
25.0V
70.7V
Maximum Output Power Per Zone
40.0W
40.0W
Operating Voltage
24VDC
Standby/Alarm Current at 24VDC
15mA
Class A
Minimum Ground Fault Sensitivity
20 k Ohms
Class B
Maximum Output Power Per Zone
40W
40W
WIRING INSTRUCTIONS:
NOTE:
The terminal blocks on the
SP4Z-A/B
are removable. To remove a terminal block, pull the block straight up from the circuit board as shown in Figure 1. Attach
wires to the desired connections, then plug the terminal block back on the board being careful to match and align the pins.
Figure 1: Removable Terminal Block
Copyright 2007 Cooper Wheelock, Inc. All rights reserved.
P84205 Rev. P
Sheet 1 of 9
