background image

P84450 F 

Sheet 4 of 4 

WARNING:  A SMALL POSSIBILITY EXISTS THAT THE USE OF MULTIPLE STROBES WITHIN A PERSON'S FIELD OF VIEW, UNDER 

CERTAIN CIRCUMSTANCES, MIGHT INDUCE A PHOTO-SENSITIVE RESPONSE IN PERSONS WITH EPILEPSY.  STROBE REFLECTIONS IN 
A GLASS OR MIRRORED SURFACE MIGHT ALSO INDUCE SUCH A RESPONSE.  TO MINIMIZE THIS POSSIBLE HAZARD, COOPOER 
WHEELOCK STRONGLY RECOMMENDS THAT THE STROBES INSTALLED SHOULD NOT PRESENT A COMPOSITE FLASH RATE IN THE 
FIELD OF VIEW WHICH EXCEEDS FIVE (5) Hz AT THE OPERATING VOLTAGE OF THE STROBES.  COOPOER WHEELOCK ALSO 
STRONGLY RECOMMENDS THAT THE INTENSITY AND COMPOSITE FLASH RATE OF INSTALLED STROBES COMPLY WITH LEVELS 
ESTABLISHED BY APPLICABLE LAWS, STANDARDS, REGULATIONS, CODES AND GUIDELINES. 

 

NOTE:  

NFPA 72/ANSI 117.1 conform to ADAAG Equivalent Facilitation Guidelines in using fewer, higher intensity strobes within the same protected area. 

CAUTION:  

Check the installation instructions of the manufacturers of other equipment used in the system for any guidelines or restrictions on wiring and/or 

locating Notification Appliance Circuits (NAC) and notification appliances.  Some system communication circuits and/or audio circuits, for example, may require 
special precautions to assure immunity from electrical noise (e.g. audio crosstalk). 

 

NOTE:

  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are 

designed to provide reasonable protection against harmful interference in residential installation.  This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.  However, there is no guarantee 
that interference will not occur in a particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined 
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  1) Reorient or relocate the 
receiving antenna,  2) Increase the separation between the equipment and receiver,  3) Connect the equipment into an outlet on a circuit different from that to which 
the receiver is connected, and  4) Consult the dealer or an experienced radio/TV technician for help. 

 

ANY MATERIAL EXTRAPOLATED FROM THIS DOCUMENT OR FROM COOPOER WHEELOCK MANUALS OR OTHER DOCUMENTS 
DESCRIBING THE PRODUCT FOR USE IN PROMOTIONAL OR ADVERTISING CLAIMS, OR FOR ANY OTHER USE, INCLUDING 
DESCRIPTION OF THE PRODUCT'S APPLICATION, OPERATION, INSTALLATION AND TESTING IS USED AT THE SOLE RISK OF THE USER 
AND COOPOER WHEELOCK WILL NOT HAVE ANY LIABILITY FOR SUCH USE. 

 

Limited Warranty 

Cooper Wheelock, Inc. products must be used within their published specifications and must be PROPERLY specified, applied, installed, operated, maintained, and 
operationally tested in accordance with these instructions at the time of installation and at least twice a year or more often in accordance with local, state and federal 
codes, regulations and laws.  Specification, application, installation, operation, maintenance, and testing must be performed by qualified personnel for proper 
operation in accordance with all of the latest National Fire Protection Association (NFPA), Underwriters' Laboratories (UL), Underwriters’ Laboratories of Canada 
(ULC), National Electrical Code (NEC), Occupational Safety and Health Administration (OSHA), local, state, county, province, district, federal and other applicable 
building and fire standards, guidelines, regulations, laws and codes including, but not limited to, all appendices and amendments and the requirements of the local 
authority having jurisdiction (AHJ). Cooper Wheelock, Inc. products when properly specified, applied, installed, operated, maintained, and operationally tested as 
provided above are warranted against mechanical and electrical defects for a period of three years from date of manufacture (as determined by date code). Correction 
of defects by Cooper Wheelock, Inc providing repairs or a replacement shall be at Cooper Wheelock, Inc.'s sole discretion and shall constitute fulfillment of all 
warranty obligations.  The foregoing limited warranty shall immediately terminate in the event any part not furnished by Cooper Wheelock, Inc. is installed in the 
product. The foregoing limited warranty specifically excludes any software required for the operation of or included in a product. COOPER WHEELOCK, INC. 
MAKES NO REPRESENTATION OR WARRANTY OF ANY OTHER KIND, EXPRESS, IMPLIED OR STATUTORY WHETHER AS TO 
MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR ANY OTHER MATTER. 

 

Users are solely responsible for determining whether a product is suitable for the user's purposes, or whether it will achieve the user's intended results. There is no 
warranty against damage resulting from misapplication, improper specification, abuse, accident, or other operating conditions beyond Cooper Wheelock, Inc.'s 
control. 
 
Some Cooper Wheelock, Inc. products contain software. With respect to those products, Cooper Wheelock, Inc. does not warranty that the operation of the software 
will be uninterrupted or error-free or that the software will meet any other standard of performance, or that the functions or performance of the software will meet the 
user's requirements. Cooper Wheelock, Inc. shall not be liable for any delays, breakdowns, interruptions, loss, destruction, alteration, or other problems in the use of a 
product arising out of or caused by the software. 
 
The liability of Cooper Wheelock, Inc. arising out of the supplying of a product, or its use, whether based on warranty, negligence, or otherwise, shall not in any case 
exceed the cost of correcting defects as stated in the limited warranty and upon expiration of the warranty period all such liability shall terminate. Cooper Wheelock, 
Inc. is not liable for labor costs incurred in removal, reinstallation, or for damage of any type whatsoever, including but not limited to, loss of profit or incidental or 
consequential damages. The foregoing shall constitute the sole remedy of the purchaser and the exclusive liability of Cooper Wheelock, Inc. 
 
In no case will Cooper Wheelock, Inc.'s liability exceed the purchase price paid for a product. 
 

Limitation of Liability 

 

Cooper Wheelock, Inc.'s liability on any claim of any kind, including negligence, breach of warranty, or otherwise, for any loss or damage resulting from, arising out 
of, or connected with any contract, or from the manufacture, sale, delivery, resale, repair or use of any product shall be limited to the price applicable to the product or 
part thereof which gives rise to the claim.  Cooper Wheelock, Inc.'s liability on any claim of any kind shall cease immediately upon the installation in the product of 
any part not furnished by Cooper Wheelock, Inc. In no event shall Cooper Wheelock, Inc. be liable for any claim of any kind unless it is proven that our product was a 
direct cause of such claim. 

FURTHER, IN NO EVENT, INCLUDING IN THE CASE OF A CLAIM OF NEGLIGENCE, SHALL COOPER WHEELOCK, 

INC. BE LIABLE FOR INCIDENTAL, INDIRECT, SPECIAL OR CONSEQUENTIAL DAMAGES.

  Some states do not allow the exclusion or limitation of 

incidental or consequential damages, so the preceding limitation may not apply to all purchasers. 

 

 

 

 

7/07

 

Summary of Contents for RSS-24MCWH

Page 1: ...LATION AND OR OPERATION OF THESE PRODUCTS IN AN EMERGENCY SITUATION WHICH COULD RESULT IN PROPERTY DAMAGE AND SERIOUS INJURY OR DEATH TO YOU AND OR OTHERS SPECIFICATIONS Table 1 UL Ratings Model Regulated Voltage VDC VRMS Voltage Range Limit Per UL 1971 VDC VRMS Strobe Candela cd Mounting Options RSS 24MCWH 24 16 0 33 0 135 185 A B C D RSSP 24MCWH 24 16 0 33 0 135 185 E F Table 1A Audibles Speaker...

Page 2: ...commodate the field wires and stresses from the wires could damage the product CAUTION Check that the installed product will have sufficient clearance and wiring room prior to installing backboxes and conduit especially if sheathed multiconductor cable or 3 4 conduit fittings are used Although the limits shown for each mounting option comply with the National Electrical Code NEC Cooper Wheelock re...

Page 3: ...witch to the desired candela setting The setting is indicated by a pointer and can be seen on the bottom side of the lens See Figures 3 and 4 below 7 Mount the SMP first to the backbox Next slide the beauty plate over the SMP until the 2 snaps of the beauty plate engage with the SMP 8 The beauty plate can be removed from the strobe assembly once engaged First gently insert a screwdriver into one o...

Page 4: ...nd fire standards guidelines regulations laws and codes including but not limited to all appendices and amendments and the requirements of the local authority having jurisdiction AHJ Cooper Wheelock Inc products when properly specified applied installed operated maintained and operationally tested as provided above are warranted against mechanical and electrical defects for a period of three years...

Reviews: