Page 10
PL12-1004EN
03/31/2010
Cleco
®
mPro400
GC
Controller
1.7
RF (Radio Frequency) Settings
1. From the NAVIGATOR menu press the TOOL SETUP menu then RF Settings. Select IRDA
Serial and the correct port depending on the port connected to at the base of the controller.
See Figure 1-17. (CON 1 and CON 2 are X4 and X5 respectively at the controller.)
2. See Figure 1-8. If serial connectivity has been made the SSID, Encryption, and remaining fields
will become available for programming. Enter a value for SSID. If Encryption is selected enter a
Network Key and confirm it by re-entering it below the initial Network key entry. If DHCP is not
being used select “Use the following IP address” and enter the IP address and Subnet mask.
Press the “Write RF settings” button.
Figure 1-7: Tool Setup - RF Settings
IRDA Serial
Port Selection
Figure 1-8: Tool Setup - RF Settings
SSID
Confirm Network
Key
Network Key
Encryption
IP Address
Write RF Settings
Summary of Contents for Cleco mPro400GC
Page 2: ......
Page 4: ...Page 4 PL12 1004EN 03 31 2010 Cleco mPro400GC Controller...
