Page 16
Silencing an Alarm
In an alarm the control unit gives a tone from the siren (except for medical alarms). The siren runs for a limited time set
by the installer (a maximum 20 minutes for intruder and PA alarms).
If you return to the system after the siren has stopped then the
lamp on the display tells you that an alarm has
occurred. If you return to the system while the siren is running you can silence the siren as follows:
Do this:
The display shows:
1
1
2
3
4
5
6
7
8
9
0
The siren stops and
the screen shows the
first zone to cause the
alarm, for example:
Burg Z02 Alarm
Homelink55
2
EITHER The display returns to normal.
OR The installer may have programmed your system so
that the screen will tell you where the alarm occurred, and
also show a message asking you to call the installer.
Burg Z02 Alarm
Call Installer
0
The display returns to the
standby screen, but the
lamp glows .
6 Dec 2005 17:22
Homelink55
Call your installer and tell them that an alarm has occurred.
