CF 136
1
09/07
List of Equipment
1. Torque Tester with 3/8” drive
2. CW
one-way
clutch
3. AC
adapter/charger
Read First: Safety Information
For safety, and for damage avoidance, be sure to read this manual thoroughly. The warranty is only valid when
the product is used following the instructions provided within this manual.
•
Do not use tester in high temperature, high humidity, or in damp or wet areas.
•
Recommended operating temperature is between 0-42ºC (32-100ºF).
•
Do not apply toque exceeding the rated capacity (180 lbf-in), regardless of whether the unit is On or Off.
Avoid shock load. Do not use with impact wrenches.
•
When charging the battery, be sure to use the provided AC adapter/charger exclusively.
•
Do not use lacquer thinner or any solvent to clean the unit.
•
Do not disassemble or modify the unit.
•
Recommended re-calibration cycle is one (1) year.
1.
ON/OFF Switch
Press once to turn on, press again to turn off (click once, do not hold). After 10 minutes of
non-use, unit shuts off.
2.
CLR/PRG Switch
To reset display, to zero and to store data.
3.
LCD Display
Displays torque value as well as low battery icon (LOBAT).
4.
AC charger/adapter receptacle
If LOBAT icon appears, 8-hour battery recharge required.
5.
System reset button
When the battery has been depleted completely and a recharge has been executed,
the system may not yet operate. In this case, press the System Reset Button.
6.
RS-232
output
7.
Wrench head swivels 300º
to allow the display to be positioned for the most convenient torque reading.
General Operation
1. Place the appropriate size socket onto the drive.
2. Rotate the wrench head so the display may be viewed while measuring and position the socket securely
over the bolt (not at an angle) and turn to measure.
3. After taking measurement, press CLR/PRG switch to zero display for the next test.
