Cooper & Hunter CH-D014WDR20, Owner'S Manual

Page: 15 / 40


Page 15

Removing the collected water
Operating
Instructions
Check filter feature
The system starts to count the time once the fan motor
operates. The check filter feature can be only activated
when the accumulated operation time achieves 250
hours or more. The Reset light(Clean filter indicator
light) flashes at one time per second, after finishing
clean the air filter, press the Filter button and the Reset
light(Clean filter indicator light) goes off.
Auto-Restart
If the unit breaks off unexpectedly due to the power
cut, it will restart with the previous function setting
automatically when the power resumes.
Setting the Timer
· When the unit is on, first press the Timer button, the
Timer Off indicator light illuminates. It indicates the
Auto Stop program is initiated. Press it again the
Timer On indicator light illuminates. It indicates the
Auto Start is initiated.
· When the unit is off, first press the Timer button, the
Timer On indicator light illuminates. It indicates the
Auto Start program is initiated. Press it again the
Timer Off indicator light illuminates. It indicates the
Auto Stop is initiated.
· Press or hold the UP or DOWN button to change the
Auto time by 0.5hour increments, up to 10 hours,
then at 1 hour increments up to 24 hours. The
control will count down the time remaining until
start.
· The selected time will register in 5 seconds and the
system will automatically revert back to display the
previous humidity setting.
· When the Auto Start & Auto Stop times are set,
within the same program sequence, Timer On Off
indicator lights illuminate identifying both On and
Off times are now programmed.
· Turning the unit On or Off at any time or adjusting
the timer setting to 0.0 will cancel the Auto Start/
Stop function.
· When LED display window displays the code of P2,
the Auto Start/Stop function will also be cancelled.
There are three ways to remove collected water
.
1. Use the bucket
· When the unit is off, if the bucket is full, the Full
indicator light will light.
· When the unit is on,if the bucket is full, the
compressor and the fan turn off, and the Full
indicator light will light, the digital display shows P2.
· Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the bucket on the
floor because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water to
spill.
· Throw away the water and replace the bucket. The
bucket must be in right place and securely seated
for the dehumidifier to operate.
· The machine will re-start when the bucket is restored
in its correct position.
1. Pull out the bucket a little.
2. Hold both sides of the bucket with even strength,
and pull it out from the unit.
3. Pour the water out.
Pump hose drops
Reinstall pump hose properly