1. Temperature control.
2. Standard freezer drawers.
3. Deep freezer drawer.
Page 3
Parts identification
The parts are listed and numbered below to help
identification.
FIGURE 1
1
2
3
Important
Make sure that the voltage marked on the rating label on the product corresponds with the voltage in your
home.
This quality product has been tested and certified to meet all applicable UK electrical and safety standards.
Installation
The appliance is designed to work in room
temperatures b16°C and +32°C. Do not
allow the room temperature to 32°C
otherwise the temperature inside the freezer will
rise.
The freezer requires space around the casing for
efficient cooling and operation. The minimum
clearances are shown in Figure 2.
There must be at least 100mm clearance between
the appliance and the rear wall
The freezer must be installed on a firm flat and
level surface for it to work quietly and efficiently.
Reversing the door may make installation more
convenient. The appliance must be tilted and
supported in order to carry this out; it is
therefore advisable to get an assistant to help
during this procedure. Take care when fitting
and tightening screws.
Door reversal
Diagrams show alternative methods of providing correct air
flow around the appliance.
FIGURE 2
100mm
100mm
25mm
25mm
Remove the temperature control dial, by pulling it
firmly away from the casing.
FIGURE 3
TEMPERATURE
CONTROL DIAL
