Coolzone CZ51153, User Instructions

Page: 6 / 16

Page 6
Detergent and rinse aid
FIGURE 9
COVER
LATCH
CAP
DOSE
ADJUSTER
LEVEL
INDICATOR
PRE-WASH
COMPARTMENT
MAIN
COMPARTMENT
Detergent
Detergent specifically intended for use with
dishwashers must be used. The dispenser must be
filled before the start of each wash cycle following
the instructions provided in the "Wash Cycle Table"
(page 9). The detergent dispenser is located on the
inside panel of the door.
Loading the detergent
The detergent and rinse aid compartments are
located on the inside of the door. Press in the latch
to open the cover. The detergent for the Wash
Cycle should be placed in the main compartment.
Wash Programmes which include a pre-wash cycle
(refer to Wash Cycle Table – page 9) require
detergent to be placed in the pre-wash
compartment.
For information on the amount of detergent to be
placed in the main and pre-wash compartments
refer to the Wash Cycle Table.
Dishwasher tablets can be placed in the main
compartment but they are not recommended for the
shorter Wash Programmes when they may not
completely dissolve during the Wash Cycle.
For the Wash Cycle the amount of detergent varies
according to the programme selected (refer to
Wash Cycle Table).
After the detergent has been placed in the
dispenser, close the cover and press down until it
"clicks" in place.
Please note: Avoid getting any excess
detergent on the edges of the dispenser
compartment as this may foul the cover when
closing.
Rinse aid
This product makes dishes sparkle and helps them
to dry without spotting. The dispenser is located on
the inside panel of the door and should be filled
after every eighty wash cycles or when the low
rinse aid indicator light
6
comes on.
Loading the rinse aid
To open the dispenser, release the cap in an anti-
clockwise direction and then pour in the rinse aid
until the level indicator turns black (Figure 9). Avoid
overfilling.
The amount of rinse aid used for each cycle can be
regulated by turning the dose adjuster, located
beneath the cap, using a coin. There are 6 different
settings; the normal dosage setting is 3.
Important:
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or
spotting occurs, turn the dosage adjuster to a
higher setting.