Wine Cooler
6
7
NOTE:
If your wine cooler has been tilted for any reason, wait 24 hours before plugging it in.
WARNING:
ELECTRICAL REQUIREMENTS - SHOCK HAZARD
NOTE:
This unit is for indoor use only.
Installation
Unpacking your Wine Cooler
•
Remove all packaging material. This includes the foam base and all adhesive tape holding
the wine cooler accessories inside and outside.
•
Inspect and remove any remaining packing, tape or printed materials before powering on
the wine cooler.
Levelling your Wine Cooler
•
Your wine cooler has two levelling legs which are located in the front corners. After
properly placing your wine cooler in its final position, you can level your wine cooler.
•
Levelling legs can be adjusted by turning them clockwise to lower your wine cooler or by
turning them counterclockwise to raise your wine cooler. The wine cooler door will close
more easily when the two front levelling legs are extended slightly.
Proper Air Circulation
•
To ensure that your wine cooler works a
ciency it was designed for, you
should install it in a location where there is proper air circulation and electrical
connections.
•
The following are recommended clearances around the appliance:
Sides…………….. 2
”
(50mm)
Top ................... 2
”
(50mm)
Back ................. 2
”
(50mm)
•
Do not overfill your wine cooler for proper cooling.
Drip Tray
•
Ensure the drip tray in the rear of the unit is in the proper position.
Electrical Requirements
•
Make sure there is a suitable power outlet (115 volts, 15 amp outlet) with proper grounding
to power the wine cooler.
•
Avoid the use of three-prong adapt
the third grounding prong in order to
accommodate a two-prong outlet. This is a dangerous practice since it provides no
Installation Limitations
•
Do not install your wine cooler in any location not properly insulated or heated (e.g.
garage, etc.). Your wine cooler was not designed to operate in ambient temperature
settings below 13˚C.
•
Select a suitable location for the wine cooler on a hard-even surface away from direct
sunlight or heat source (e.g. radiators, baseboard heaters, cooking appliances, etc.). Any
floor unevenness should be corrected with the levelling legs located on the front and rear
bottom corners of the wine cooler.
•
Your wine cooler is designed for freestanding installation only. It is not designed for
built-in application.
Use of Extension Cords
•
Avoid the use of an extension cord because of potential safety hazards under certain
conditions.
