background image

2

3

SAFETY INSTRUCTIONS

• Keep the ice packs (supplied) away from the 

children as they contain chemical based 
crystals.

• DO NOT use this unit for functions other than 

those described in this instruction manual

• DO NOT tilt the unit. Always keep in upright. 

Position on a flat and stable surface, where 
it cannot be easily knocked over. Take extra 
care when operating 

• DO NOT cover or obstruct the air filter inlet or 

outlet grilles

• DO NOT use the unit in a wet room, such as a 

bathroom or laundry

• DO NOT sit or place articles on the unit
• DO NOT touch the unit with wet hands or bare 

feet

• DO NOT let chemical substances come into 

contact with the unit

• DO NOT use the unit in the presence of 

inflammable substances or vapour such as 
alcohol, insecticides, petrol etc.

• DO NOT use the mains plug to start and stop 

the unit

• DO NOT pull the supply cord or place it near 

a heat source. Always unwind the cord 
completely to avoid overheating. If the supply 
cord is damaged it must be replaced by the 
service agent or a similarly qualified person, 
in order to avoid a hazard

• DO NOT allow children to play with this 

appliance. This appliance is not intended 
for use by children or infirm persons without 
supervision.

• DO NOT conduct repairs on this unit. It has 

been built in accordance with relevant safety 
and performance standards. An electrical 
specialist must carry out all repairs.

• If the power cord is damaged, it must be 

replaced by a qualified electrician

• DO NOT use the unit without the filter fitted
• DO NOT allow objects to enter any ventilation 

or exhaust other than ice or water as 
specified in these instructions

• This unit is intended for indoor use only.
• ALWAYS unplug the unit from the mains before 

maintenance or cleaning

• ALWAYS use the switch on the control panel to 

start and stop the unit

• ALWAYS keep a clearance of at least 20cm 

from walls furniture and curtains

• ALWAYS turn off and unplug the unit when not 

in use

• ALWAYS switch off, and unplug the unit before 

filling up with water or ice

• Adequate clean water should be put into 

the water tank within the water level limits 
shown on the level indicator.

• Should you wish to move the unit any great 

distance, or before storing it, always drain the 
water from the tank using the plug provided at 
the bottom of the unit.

• When draining the water tank always do this 

over a bucket, outside so that water does not 
damage the carpet or flooring

ENERGY SAVING TIPS

• Use the unit in the recommended room size of 

up to 20m

2

 (assuming standard 2.4m ceiling 

height)

• Do not locate the air conditioner where 

furniture or other objects can obstruct the air 
flow.

• Keep blinds/curtains closed during the 

sunniest part of the day

• Close the fireplace damper, floor and/or wall 

registers, so cool air does not escape through 
the chimney or duct work

• Keep the air filter clean
• Set the unit to maximum cooling and high 

speed ventilation for the initial startup, then 
adjust the unit down to a more comfortable 
setting as required

CWEC01 Instructions copy.indd   2

15/07/10   2:02 PM

Summary of Contents for CWEC01









Reviews: