Chapter 3 Wiring diagram and module connection diagram
9
Make sure the sensor cable is fully inserted into the terminal.
Sensor/crimp terminal connection spec AWG28~16 (DI:
0.32~1.295mm).
Fix the sensor to make the measurement more accurate.
3.2.2 Power connection
Power supply wiring, please refer to
1.3.2 Bottom-power wiring
Use AWG 24 ~ 12 specifications for the power cord.
First calculate general power according to the usage and then
connect the corresponding power.
3.2.3 Communication connection
For the communication connection, please refer to
1.3.1 introduction
.
3.3 Preparation and start
3.3.1 Overall sequence of operations
Perform the following steps before operating the CM -4TM for the first time.
1. All external devices, sensors and loads are connected to the CM -4TM terminals.
2. Modify the relevant parameters (PC, GP, etc.) through the external connection device.
3. Load the set parameters into the CM -4TM.
4. After setting the SV value, perform auto-tuning. Use this product after self-tuning.
品。
3.3.2 Set value status when power-on
Setting type
Factory
default
Value before
power-on
Value after
power-on
Com address(CH1)
※
1
auto/ manual
auto
auto
auto
400004(0003H)
manual
manual
Run/stop
Run
Run
Run
400051(0032H)
Stop
Stop
