8 U2CHGRHUB10 – Product Manual
www.coolgear.com
2)
Plug the power adapter to the unit’s power jack.
•
The power jack is threaded with nut, so user may put power DC plug into the
power jack without losing connection.
3)
Put the plug of power adapter into the wall outlet.
4)
Turn on the power switch. (
Front Panel
)
5)
Using the USB A to B cable provided, connect the USB B end on the unit.
6)
Using the USB A end and connects on your host computer.
7)
Connect the host unit with the computer. (
Rear Panel
)
8)
Use the USB cable to connect it to the charging ports, then tablets or USB
devices. (
Front Panel
)
1.7
Charging & Syncing
Please follow below ways for charging or syncing USB devices.
1)
Follow the step of connection with host computer, and connect host computer
with the unit.
•
This unit does not contain an accessory set of cables fro iPad or tablets.
Please check with your distributor regarding the use of appropriate cables.
2)
Connect your USB devices to the USB ports on the hub.
•
Sync Mode
– As soon as the charging hub connects to a computer, turn the
power on; the charging hub may charge and sync at a time either at single
unit or cascade connecting.
•
Charge/Sync Mode Switching
a.
While the charging hub disconnects the computer, it will switch
function to charge mode. Re-connect the computer and it will switch
function to sync mode again either at single or cascading units.
b.
The hub will shut down in 60 seconds if it is idle and there are no
devices connected. You may manually turn on the power switch either
at single unit or cascade connecting and start charging again.
c.
Or, you may re-connect to the computer to restart the charging hub
and it will switch function to sync (CDP mode) again either at single or
cascading connecting. (Make sure both unit’s power switches are
turned “ON”)
•
If all devices are fully charged at charge mode, the charging hub will shut
down automatically. You may manually turn on the power switch or re-
connect to the computer and start charging again.
•
Re-start the hub on cascade connections
– If the two hubs are cascade
connecting, you must turn their power on for both hubs. Once the 1
st
hub is
disconnected from the computer, both hubs will switch to charge mode, and
work on the same function. On the contrary; once the 1
st
hub is connected to
the computer again, both hubs will re-start and switch to sync mode and
