8. Finish ceiling, then install grille.
Squeeze grille springs and insert into slots in housing. Push
grille up against ceiling.
3. Remove old fan.
Enlarge ceiling opening (if necessary) to 9¾” parallel to joist) by
10½” (perpendicular to joist). Leave ductwork and wiring in place.
7. Connect 4-in. round duct.
Pull existing ducting through housing discharge opening and tape
ducting to duct connector. Push connector/ducting back through
opening. Engage tabs and secure with screw from parts bag.
6. Mount fan to ceiling structure.
SWITCH BOX
ON / OFF SWITCH
(purchase separately)
WHITE
BLACK
GROUND
(bare)
WIRING PLATE
120 VAC LINE IN
RECEPTACLE
1
2
3
4
TABS
1
2
*
4. Fold mounting ears flat against housing.
7. Install blower.
Re-install blower. Secure blower with 2 screws from parts bag
and plug blower into black receptacle.
RETROFIT
Limited Warranty
In the sale of its products, American Coolair Corporation
agrees to correct, by repairs or replacement, any defects in
workmanship or material that may develop under proper and
normal use during the period of one year from date of shipment
from factory. Any product or part proving, upon American
Coolair’s examination, to be defective during limited warranty
period will be repaired or replace, at American Coolair’s option,
f.o.b. factory, without charge.
Deterioration or wear caused by chemicals, abrasive action or
excessive heat shall not constitute defects.
Motors are guaranteed only to the extent of manufacturer’s
warranty.
American Coolair’s limited warranty does no apply to any of its
products or parts that have been subject to accidental damage,
misuse by the user, unauthorized alterations, improper
installation or electrical wiring, or lack of proper lubrication of
other service requirements established by American Coolair.
Repairs or replacements provided under the above terms shall
constitute fulfillment of all American Coolair’s obligations with
respect to limited warranty.
THE LIMITED WARRANTY STATED HEREIN IS IN LIEU
OF ALL OTHER WARRANTIES. EXPRESS, STATUTORY
OR IMPLIED, INCLUDING WITHOUT LIMITATION THAT OF
MERCHANTABILITY AND FITNESS.
NO LIABILITY FOR REINSTALLATION COST OF FOR ANY
SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES OF
ANY NATURE IS ASSUMED OR SHALL BE IMPOSED UPON
AMERICAN COOLAIR.
AMERICAN COOLAIR CORP. / ILG INDUSTRY
3604 MAYFLOWER ST.
JACKSONVILLE, FLORIDA 32205
TEL: 904-389-3646
5. Connect wiring.
Bend tab to expose desired
access hole. Connect power
cable to housing with appropriate
UL approved connector. Connect
black to black, white to white and
green to green or bare wire. Re-
install wiring panel and secure
with screw from parts bag.
Mount housing to ceiling
structure with standard
drywall or wood screws in
locations shown. *Center
hole optional.
Install blower. Finish ceiling, then install grille.
See Steps 7 & 8 at top of this page..
WIRING DIAGRAM
99045669B
