COOL HEAD 0CRW0086, Instruction Manual

Page: 11 / 78

P2M036STD-Ver1.2 10
GB
Troubleshooting
Fault Potential Failure Problem solving action
The appliance is
not working The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug and/ or lead are damaged Call your agent or qualified technician
Fuse in the plug has blown Replace the fuse (UK Plug)
Power supply Check power supply
Ambient temperature below 10⁰C Move appliance to warmer position
Thermostat (Ice Cube) is set to OFF
or 0 position Set the thermostat to working position
The appliance
turns on, but the
cycle times are too
long/ no ice is
produced Condenser blocked with dust Call your agent or qualified technician
Condenser filter is blocked Clean the condenser filter
Water supply Check water supply, water pressure, hoses
not blocked, hoses connected properly
Water inlet valve blocked Clean the water inlet valve
Thermostat (Ice cube) is set too high
(Icecube too big) Set the thermostat to a lower position
Appliance is located near a heat
source or air flow to the condenser is
being interrupted Move the appliance to a more suitable
location
Ventilation holes are blocked Check distance to other objects and keep
ventilation holes clear
Ambient temperature is too high Increase ventilation or move appliance to a
cooler position
Ice cube is
incomplete or
cloudy Bad potable water quality Install a filter system
Spray system is blocked Clean the sprayhead and the nozzles, make
sure the sediment catcher is cleared
Spray nozzles on the spray head are
misaligned make sure that the nozzles are assembled
in 90 degree to the spray head (not slightly
rotated)
The appliance is
unusually loud Loose nut/ screw Check and tighten all nuts and screws
The appliance has not been installed
in a level or stable position Check installation position and change if
necessary
The appliance is not properly leveled Adjust the screw feet to level the appliance
(if applicable)
The appliance is
leaking water The discharge outlet is blocked Clear the discharge outlet
The discharge hose or water inlet
pipe is damaged Replace the hose
Seal of water inlet pipe is missing or
defect Replace the seal