Issue 2 05/08/2021
7
FOOD PROCESSOR - BASIC OPERATION
1.
Assemble the food processor as described in the above
section.
2.
If using the general purpose blade the ingredients can be
added into the bowl before fitting the lid. Advice for using
the julienne, slicing and shredding blades are given in the
following section.
3.
Fully unwind the food processor cable and plug in.
4.
Switch on at the mains and using the speed switch, select
the processor speed of choice. A slower mix will be obtained
by selecting the lower speed setting 1 and a faster mix by
selecting the higher setting 2. Use for a maximum of 90
seconds.
5.
Switch off, allow the blade or blade holder to stop spinning
before checking the consistency of the mix / cut. If
satisfactory, remove the processor bowl from the motor
housing.
6.
If further mixing is required, wait 2 minutes before restarting
the processor. If the unit is used for 3 consecutive cycles,
wait 30 minutes before the next use.
7.
To use the processor on pulse, turn and hold the speed
switch to the ‘P’ position for short intervals. The processor
will operate at full speed and when the desired mix is
achieved, release the switch.
8.
To stop or interrupt the food processor switch the appliance
off by turning the speed control switch to the off (0) position
or by turning off at the mains.
Summary of Contents for FP9076-GS
Page 13: ...Issue 2 05 08 2021 13 ...
