background image

 

ISSUE-1 20/10/2017  

5

To use 

– Basic Operation 

1.

 

Place  the  coffee  maker  on  a  stable,  flat,  heat  resistant  surface 
and away from surfaces that may be damaged by steam. 

2.

 

Swing  open  the  filter  holder.    Fit  the  mesh  filter  into  the  filter 
holder  and  add the  fresh  ground coffee  for the  required number 
of  cups  into  the  mesh  filter  according  to  personal  taste.    Close 
the filter holder and check that it is fully engaged. 

3.

 

Lift the reservoir lid and fill with water to the required level using 
the  graduated  markings  on  the  reservoir  as  a  guide.    Do  not  fill 
past  the maximum  10  cups  (otherwise water will  flow  out  of  the 
overflow  point  onto  the  work  surface)  or  fill  below  the  minimum 
(3 cups) levels.   

4.

 

Close the reservoir lid and place the glass jug onto the hotplate. 

5.

 

Fully  unwind  the  cable  and  plug  in,  the  display  will  briefly 
illuminate and the time digits ‘12 00’ will flash.  

6.

 

For safety do not allow the cable to dangle over the edge of units. 

7.

 

Press  the  ON/OFF  (

)  button,  the  red  ‘on’  indicator  will 

illuminate and the coffee maker will start to operate. 

8.

 

The  coffee  maker  element  will  switch  off  automatically  when  all 
the  coffee  has  been  brewed  but  the  ‘on’  indicator  will  remain  lit 
for  40  minutes  to  indicate  that  the  hotplate  is  still  keeping  the 
coffee warm. 

9.

 

Switch  the  coffee  maker  off  using  the  ON/OFF  button  when  the 
jug  is  empty  and  to  avoid  damaging  the  glass  jug  never  replace 
the empty glass jug onto the warm hotplate. 

10.

 

To  stop  or  interrupt  the  coffee  making  process,  switch  the 
appliance  off  using  the  ON/OFF  (

)  button  or  unplug  from  the 

mains. 

11.

 

After  use,  remove  and  empty  the  mesh  filter  (or  remove  paper 
filter, if used) and throw the waste grounds away.  

 

Notes: 

 

Before  using  for  the  first  time,  fill  the  coffee  maker  to  the 
maximum level with clean water, close the lid and allow the coffee 
maker  to  work.    Do  not  use  the  mesh  filter  and  discard  the  hot 
water after it is finished.   Wash the loose parts (mesh filter, filter 
holder, glass jug and jug lid) in hot water with a little washing up 
liquid. Rinse and dry thoroughly.  Not suitable for the dishwasher. 

 

 

Summary of Contents for CM2021T










Reviews: