7
ASSEMBLY
• BEFORE ASSEMBLY READ ALL INSTRUCTIONS CAREFULLY.
• ASSEMBLE UNIT ON A CLEAN, FLAT SURFACE.
• TOOLS NEEDED: ADJUSTABLE WRENCH, PHILLIPS HEAD SCREWDRIVER
Carefully position grill as shown.
Do not tighten screws all the
way. Leg frames may need to be
adjusted during assembly.
STEP 1
Attach rear legs (10), right front leg
with matchstick and chain (8) and
left front leg (9) to bottom of smoker
body (1) using phillips head screw
(A).
Do not fully tighten screws yet.
STEP 2
Attach control panel (11) to right
front leg (8) as shown using
phillips head screw (A) and secure
with fl ange nut (C).
Repeat on opposite side attaching
contol panel (11) to left front leg (9).
A
A
10
1
9
8
A
11
8
9
C
1
12
ASSEMBLY
STEP 12
Hang matchstick (15) on side of
smoker body (1) as shown.
1
15
STEP 11
Insert small hook end of grease
clip (7) all of the way up through
large hole in bottom of smoker
body (1) so that it is supported on
small tab.
Position drip cup (6) on grease clip
so it rests snugly.
Note:
Drip cup is needed to collect
grease run-off.
Clip may require adjustment to fi t
diameter of container.
6
7
1
