Conviron GEN1000-GE, Operator'S Manual, Page: 41 / 54

Maintenance
November 8 2019 | 291180-ENG R00 33
6.5 Performing Maintenance in the Machine Compartment
The machine compartment is located on top of the chamber and should only be accessed by
qualified service technicians.
To perform maintenance in the machine compartment:
1. Turn the power to the chamber OFF. Refer to Section 6.1 Disconnecting the Power
before Maintaining or Servicing the Chamber on page 28 for instructions to turn off
the power.
2. Use a ladder to access to the top of the chamber. Do not stand on the chamber.
3. Remove the screws from the perimeter of the top compartment cover.
4. Lift the front edge of the cover, using the handle provided.
5. Slide the cover off and carefully lower the cover down to the floor.
6. Perform the required maintenance.
7. Reposition the machine compartment cover.
8. Re-install the cover screws to secure the cover to the chamber.
Take care when removing and re-installing the top cover screws to avoid stripping the
screw threads. Do not use a high torque setting on an electric driver.
Re-install the top cover with the handle facing the front of the chamber to position the
ventilation grill over the controller assemble in the machine compartment.