Resolution Mode-
If output is selected as RGB, press the up and down
buttons to choose from 640 x 480 (VGA), 800 x 600 (SVGA), 1024 x 768
(XGA) or 1280 x 1024 (SXGA) PC output. If output is selected as YPbPr
press the up and down arrows to choose from 480p, 576p, 720P or 1080i
HDTV output.
Output Mode-
Press the up and down arrows in order to select between
PC RGB output and HDTV YPbPr output.
Aspect Mode-
Press the up and down arrows in order to select between
standard (4:3) aspect and wide (16:9) aspect ratio.
3D Enhance Mode-
This mode is used to turn on or off the 3D comb filter
function. When VCR or non-standard video source is connected to the
input the output picture may be jittering. If this occurs, please turn off the
3D enhance function.
Digital NR Mode-
To turn on or turn off the digital noise reduction
function.
2.
Picture-
Press this button and it will toggle through the following
picture adjustment parameters- Contrast-Bright-Colour-Tint-Sharpness.
Contrast-
Press the up and down arrows in order to adjust the picture
contrast level (0~48).
Bright-
Press the up and down arrows in order to adjust the level of
picture brightness (0~48).
Colour-
Press the up and down arrows in order to adjust the colour
saturation level (0~48).
Tint-
Press the up and down arrows in order to adjust the tint level (0~48).
Sharpness-
Press the up and down arrows in order to adjust the sharpness
level of the picture (0~48).
3. ▲- ▼
Press these buttons in order to toggle through the adjustment
controls.
4.
IR Sensor-
This is the infrared remote control sensor.
5.
Power and LED button-
press once to power on the unit, press again to
turn off the unit.
6.
Front Panel lockout-
under certain circumstances it may be desirable
to disable the front panel controls. In order to do so, press the front panel
lockout to ON position. To lift the lockout and revert all parameters back
to factory preset values, please press mode and picture buttons
simultaneously for over 10 seconds.
NOTE-
Under the picture adjustment mode, press the up and down
arrows simultaneously and it will revert the selected parameter back to
the factory-preset value. Press both buttons for over 5 seconds and it will
revert all picture adjustment parameters back to their factory-preset
values.
