ALSPA PROFIBUS Field Bus Coupler
7. Menu 74 Parameters
(09/06)
Technical Manual
Page 7-1
7. Menu 74 Parameters
7.1 Introduction
This section describes the method of controlling the PROFIBUS
board, using the drive parameters available in Menu 74.
The section gives a list of those parameters necessary to get the
PROFIBUS link operational, and then details the functions of the
remaining parameters. The section ends with a list of all the
parameters associated with the PROFIBUS board.
7.2
PROFIBUS Menu 74
The configuration of the PROFIBUS board is implemented via
Menu 74, which will be visible if the CDC recognises the presence
of an appropriately configured Fieldbus Coupler (see sections 3.3.2
and 3.4.1). Menu 74 is fully described in Section 7.4.
7.3
Basic Settings Explanation
The basic settings are those required to get the PROFIBUS board
operating and to define the basic operating modes of the board.
A block diagram is provided at the end of the manual to help with
configuration of the PROFIBUS board.
The stages in configuring a MVS3007-4001 or MVS3007-4002
PROFIBUS board are as follows:
1. Set up the PROFIBUS network node address in
Parameter 74.02
2. Select and set up the PPO type in Parameter 74.03
3. Configure the PROFIBUS references and PROFIBUS
control words in Menu 74.
4. Set P74.05 to 1 to configure the link.
4
If at any time the PPO type is changed then it is necessary to power cycle the drive
for the change to take effect.
