Converging Systems IMC-300MKII-EM, Manual, Page: 7 / 38

.
Converging Systems Inc. Page 7 Rev.5.0.0
Figure 3
General Information:
•
For Ethernet Connections -- Use 22-24 AWG CAT5 (or better) interconnection wires with maximum length of
bus less than 328 feet (100m) for Ethernet connections.
•
For Serial Connections -- Use 22-24 AWG CAT5 (or better) interconnect wires with maximum length of bus less
than 50 feet (15.25m (if using 4 pair wire, simply do not use the Brown and Brown/White of 4
th
pair wires).
•
For CS-Bus Connections --Use 22-24 AWG CAT5 (or better) interconnect wires with maximum length of bus
less than 4000 feet (1219m) (if using 4 pair wire, simply do not use the Brown and Brown/White of 4
th
pair wires).
•
For STI/LV and Door Controls -- Use 18-22 AWG interconnect wires with maximum length of run of 10 feet
(3.04m). Since there is no data communication on these channels, you may use any wiring configuration you
desire.
•
Route Low Voltage wires through a separate entry or knockout from AC Supply and Motor connections.
3.1 Ethernet Communication Wiring Directions (Internet Protocol). ( See Figure 3 above .)
Directions
a. Prepare Ethernet communication wire (Cat5 or better) with RJ-45 connectors on each end. Do not
exceed the maximum run of 328 feet (100 meters).
b. Plug one end of the above cable into the IP Connector on the IMC-300MKII-EM Controller and the
other end to a network switch through which control to a remote integration platform is connected.
Note: In the case of a multiple IMC-300MKII controllers, only one connection to the IP Connector on the
master controller (the IMC-300MKII-EM Controllers) is required.
3.2 RS-232C Communication Wiring Directions (Serial-RS-232c Protocol). ( See Figure 3 above .)
Directions
a. Prepare Ethernet communication wire (Cat5 or better) with RJ-45 connectors on each end. Do not
exceed the maximum run of 328 feet (100 meters).
b. Plug one end of the above cable into the RS-232C Connector on the IMC-300MKII-EM Controller
and the other end to a Stewart provided RJ-45 to DB-9 dongle. Do not exceed a run of 50 feet
(15.24m) in this case.
Door Block
STI/LV Block
IP (Ethernet)
CS-Bus Port 1
CS-Bus Port 0 (powered)
RS-232c
Pin 1