6.
Temperature limiting control
This heater is equipped with manual reset control. In case of a malfunction of
the unit (blocked air output or intake, for example) the heater will stop heating
automatically. After correcting the malfunction the heater can be reset. Push the
button on the upper back panel of the heater.
Maintenance
6
To keep your CONVECTAIR unit clean,
regular maintenance is suggested. To remove
dust, use a soft cloth. To remove a stain, use
a damp cloth. For a better performance and
a maximum efficiency, it is suggested that
dust and lint be regularly removed from the
protective grille situated at the base of your
Convectair (Figure 6).
Figure 6
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS TO CLEAN THE HEATER AS THIS MAY
CAUSE DETERIORATION OF THE EPOXY FINISH.
ANY REPAIR ON YOUR CONVECTAIR HEATER SHOULD ONLY BE DONE BY A QUALIFIED TECHNI-
CIAN AFTER DISCONNECTING THE HEATER.
Operation and Maintenance TIPS
Your CONVECTAIR heater will become hot when in use. Caution is advised when
young children are present.
Do not insert small objects through the front louvers : this could cause electrical short-
circuit, fire or damage to the inner components.
Any use or modifications not approved by CONVECTAIR may cause electrical short-
circuits, fire or injuries to the users.
In certain cases, it is possible for yellowing of the grille to occur over time. This is
not due to a manufacturing defect. This is caused by surrounding air, which contains
smoke or dust, being heated and released through grille.
Prevention :
it is suggested that grilles be frequently cleaned especially
with units installed in locations where cigarette smoke is present or in the
kitchen. Never use this heater during construction work or other activities
that generate a lot of dust.
Note :
The first time your CONVECTAIR heats, a light smoke could be
released. This is normal and should disappear after about 2 to 3 minutes.