Setup and Moving Instructions
1. Unfold the legs and stand the frame up as shown. Install (2) #9 hex head bolts and
(2) #10 lock nuts. Tighten all (4) leg bolts and lock nuts.
2. Slide boom over trapeze frame and install (2) #7 bolts and (2) #6 nuts. Tighten.
3. Slide trapeze bar and strap assembly over boom and adjust to desired height.
Warning!
Set trapeze on level floor. Failure to set up properly may damage the
trapeze and cause bodily injury to users or attendants.
Only thread strap through buckle in the way shown
here! Threading in any other way may cause the
strap to fail.
When adjusting strap for desired trapeze bar height,
make sure there is at least 2 inches of strap left on
either end of the buckle as shown.
If strap becomes torn or frayed replace immediately
4. To use transport wheels, Remove (2) #9 bolts and fold legs up. Tilt frame 15-25° back
and carefully roll to new location.
5. After transporting trapeze, reassemble leg bolts and tighten.
6. Trapeze may be free standing or anchored to the floor using the (4) brackets provided.
Warning!
Moving the trapeze on the transport wheels can be very dangerous.
Use extreme care! The person moving the trapeze must be able to handle the
weight. Do not tilt the frame more than 25°, do not let the center of gravity
become to low. Keep a firm grip on the trapeze.
