8
3.6
Fan/pump not running
fast enough on low speed.
3.7 Pump drive belt faulty or
broken.
3.6.1 Check that supply voltage is up to correct level.
3.6.2 Fan and pump will pick up speed slightly as the
motor reaches normal operating temperature. Allow the
cooler to run for 30-60 minutes and check again. If there is
no improvement have the cooler checked by a service
agent.
3.7.1 Replace drive belt as shown on page 7.
4.1 Reservoir or Aspen
cooling pad dirty.
4.2 Water quality is poor.
4.1.1 Drain reservoir and fill the cooler with clean water. If
it still smells clean the reservoir and replace the Aspen
cooling pad or proceed to 4.2.1.
4.2.1 Add a little vanilla essence or perfume to the water.
4. Cooler makes bad
smell.
5.1 Dirt has accumulated
inside pump.
5.1.1 Proceed as in 3.5.1
5.1.2 Replace drive belt as shown on page 7.
5 .
C o o l e r
m a k e s
scraping or rattling noise
on new season start up.
6.1
Too much water in
reservoir.
6.2 Water level indicator not
working.
6.1.1 Drain some water out (see page 7).
6.2.1
Remove the rear panel for access. Slide the
indicator up to the 'FULL' position then let it drop. If it fails
to operate have it checked by a service agent.
6. Water overflows from
reservoir.
7.1 Electrical fault.
7.1.1 Electrical parts must only be repaired and replaced
by Authorised Service Agents.
7. Cooler will not
operate at all.
8.1.1
If the power supply cord of this appliance is
damaged it must be replaced. Electrical parts must only
be repaired and replaced by Authorised Service Agents.
8. Damaged power
supply cord.
3. No cooling.
3.1 Cooling control is off.
3.2 Reservoir is empty or
nearly empty.
3.3 Weather is too humid.
3.4 Aspen cooling pad and /
or pump inlet screen blocked
or dirty.
3.5
Pump is not working
properly.
3.1.1 Turn cool knob to 'COOL'.
3.2.1 Fill with water again until water level indicator is at
the 'FULL' position. Water capacity is 14 litres
3.3.1 Turn cool knob to '0' and use cooler as a fan only.
3.4.1 Clean parts - see maintenance page 7.
3.5.1 The pump is NOT a separate electric pump. It is
connected to the fan motor and is driven mechanically.
Turn the cooler off and completely drain the reservoir.
Refill with water. Switch fan knob to high speed (3), turn
the cool knob to 'COOL',run the cooler for 10-15 minutes
non-stop. This will help dissolve and flush out the dirt. The
Aspen cooling pad should now be wet. If the pad is not
visibly wet and there is no cooling, have the cooler
checked by a service agent.
1. Cooler will not operate
at first.
2. Cooler stops operating
after running for some
time.
1.1 Power outlet or supply
faulty.
2.1
Motor overheated
(safety cutout).
1.1.1 Switch on power outlet.
1.1.2 Check power supply.
1.1.3 Check power outlet.
1.2.1 Check that power supply is the same as specified
on the rating label.
2.1.1 Wait 30-45 minutes for motor to cool down and it will
restart automatically. If condition persists take the cooler
to a service agent.
TROUBLESHOOTING
CONDITION
POSSIBLE CAUSE
REMEDY
