OPERATION cont.
Timer Function
Step 8: Setting the timer
How to cancel the timer
The air conditioner is fitted with a timer
function. This can be set up to 24 hours in
advance. To use this function, the cooler
must be plugged in and ready to operate.
With the air conditioner ON, press the
TIMER button on the remote control or
control panel to set the number of hours
before the air conditioner powers off.
The control panel display will flash and
show the time setting. Press the “+” or “-”
buttons to increase or decrease the time in
1 hour increments from 1 - 24 hrs. After 5
seconds the display will stop flashing and
the TIMER symbol will be lit on the display
panel (Fig 8).
When the air conditioner is OFF (but still
plugged in), repeat the above to set the
number of hours before the cooler powers
ON. The air conditioner will start up with the
last settings used.
When the air conditioner is working,
only the TIMER OFF can be set. When the
air conditioner is off, only the TIMER ON
can be set.
To cancel the timer, simply press the TIMER
button again. The TIMER indicator will stop
glowing.
Note!
CP12CS1 Portable Refrigerated Air Conditioner
8
Draining the Air Conditioner
To drain the air conditioner, place it over a
drain point before unscrewing the cap and
removing the drain plug, as water will flow
out as soon as the plug is removed.
Remove the plug at the bottom rear of the
appliance and allow the tank to
completely drain (Fig 13B).
Note! Always replace the drain plug
immediately after draining.
Always disconnect the air conditioner from the electricity mains before cleaning or
draining.
To maximize the efficiency of the air conditioner, clean regularly.
Never operate the air conditioner without the filter.
Cleaning the housing
Cleaning the filters
Note!
Use a soft, damp cloth to wipe the body clean.
Never use aggressive chemicals, spirits, detergents, chemically treated cloths, or other
cleansing solutions. These substances could possibly damage the cabinet
Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt and then rinse
under running water (no hotter than 40°C).
Dry thoroughly before replacing.
Take care to replace the filter back into the slot in the cooler.
.
Remove the filter from the top air inlet vent as shown (Fig 13A).
End of season storage:
•
Drain any water from the unit.
•
Operate the unit in fan only mode for a few hours, to thoroughly dry the inside.
•
Clean or change the filter.
•
Replace in the original carton or cover for storage.
•
Unplug and carefully store the power cord and plug end.
MAINTENANCE
B
13 A
Remove filter from the
air conditioner and
clean every 2 weeks.
9
SEELEY INTERNATIONAL
–
OWNER
’
S MANUAL
