HK
The mounting must be vertical when it is
correctly installed, screw into place using
the same screw that holds the clamp strip.
Remove the inner screw on the plate
at the grate control. Secure the tem-
perature sensor in the hole using
the M6x20 screw supplied.
Loosen the screws holding the back
plate approximately 3 turns. Install
the flow guide as illustrated and
tighten the screws.
The temperature sensor must only
be attached using cable terminals.
Impacts on the cable sheath are
potentially lethal.
!
!
In case of not using the fire over
a longer period (e.g. during the
summer) please unplug the fan.
This is to protect the fan’s sensitive
electronics against lightning strike.
GB
11