Step 4: Fix the Keypad to the Case
Fix the keypad to the case using the security screws provided. NOTE: Ensure the
nylon sealing washers are located beneath the head of the security screws.
Check to ensure that the gasket is in place and compressed evenly around the
perimeter of the case
3
Programming the Keypad
Step 3: Programming the Keypad
To change the programming, set the “Run / Prg” switch on the rear of the keypad to
the “Prg” position. The LED on the keypad will start to flash red, press
#725
and the
LED will change to green. Select the required options:
Set the Site Code to 0 by entering
100000
For Wiegand 26 bit:
- To Set Wiegand 26 bit with keypress beep - enter
26
- To Set Wiegand 26 bit with no keypress beep - enter
24
For Wiegand 34 bit:
- To set Wiegand 34 bit with 5 digit PIN - enter
40
- To set Wiegand 34 bit with 6 digit PIN - enter
41
- To set Wiegand 34 bit with 7 digit PIN - enter
42
- To set Wiegand 34 bit with 8 digit PIN - enter
43
- To enable / disable keypress beep in 34 bit mode - enter
49
When all configuration changes are done, press
0
to exit programming mode and the
LED will change from green to flashing red.
Finally, change the “Run / Prg” to the “Run” position and the LED will change to solid
red.
