ControlOMatic CHLOR MAKER 10 Operating Instructions Manual Download Page 2

INTRODUCTION

ChlorMaker is a semi-automated, salt water chlorine generation system specifically designed for portable spas up 

to 1,250 Gallons.  ChlorMaker generates chlorine from a small amount of ordinary salt (Sodium Chloride, NaCl) 

dissolved in the spa water.  The amount of salt added is very small in relation to the volume of the water in the spa.    

It’s about 90% less concentration than ocean water and below the typical taste level of most humans.

  

The small addition of salt also benefits users by providing a softening effect on the water, leaving hair and skin feel

-

ing smoother and healthier than with traditional sanitizing products.  Only 2.5 cups of salt per 100 gallons of water 

is all it takes for ChlorMaker to produce fresh, pure chlorine leaving your water clean and clear day after day.

IMPORTANT SAFETY INSTRUCTION

WARNING

:    Use ChlorMaker only according to these instructions.  Any modification or misuse of this product    

 

 

will void the warranty.

WARNING

:  

Install ChlorMaker in accordance with all national and local electrical, plumbing, safety, and other   

 

 

applicable codes.

WARNING

:  

Connect ChlorMaker to a GFCI (ground fault circuit interrupt) or GFI (ground fault interrupt)

 

 

protected 110 or 220 VAC power source only.

WARNING

:  

Protect the power supply and outlet from exposure to the elements including direct sun, rain, snow,  

  condensation, 

etc.

WARNING

:  

DO NOT allow children to operate ChlorMaker unless under adult supervision.

WARNING

DO NOT insert objects into, or tamper with ChlorMaker’s body in any way.  Inserting metal objects  

 

 

into the body may cause damage and void the warranty.

WARNING

DO NOT operate ChlorMaker if damaged in any way.

WARNING

:  

DO NOT pull on the cord to disconnect the Power Supply from power source.  Do not allow the    

 

 

cord to rest on sharp edges or corners or to be walked upon.  Do not drop, throw, or otherwise    

 

 

rough handle ChlorMaker.

WARNING

:    Unit must be disconnected from power source before performing any maintenance or 

 

 

troubleshooting operations.

CAUTION

Leave spa cover open at least 30 seconds to allow trapped gases to escape prior to use.

CAUTION

If unit is not working properly, or has been damaged in any way, contact technical support

 

 

immediately at 1-530-205-4520.

CAUTION

Measure water quality parameters and adjust if necessary prior to each spa use.

CAUTION

Make sure all spa electrical components and power cords have been thoroughly inspected by a

 

 

licensed electrician prior to using ChlorMaker.

Summary of Contents for CHLOR MAKER 10













Reviews: