Web Server
XW-112™ Wi-Fi Water Detector Users Manual
Section 3: Web Server
The internal web server presents two classes of web pages:
Setup
pages and
Control
pages.
Setup
pages are used by an installer to provision and configure the XW-112. The
Control
page displays water
sensor and battery status information. The Control Page displays measurement and status information
for the user.
To access the
setup
pages, enter the following URL in the address bar of your web browser:
To access the
control
page, enter the following URL in the address bar of your web browser:
http://192.168.1.2
The internal web server is always enabled and it can be accessed any time.
Note that if you are accessing the unit as an access point, the above IP address will work even if you
have previously changed the IP address or port in the setup pages. If you are accessing the unit through
the network after it has been configured, you will enter the IP address that was assigned to the device.
If the XW-112 has been added to a network using WPS, it will use DHCP and you will need to use the IP
address assigned to it by the DHCP server or router. This can be found by logging into the DHCP
server/router, or by using mDNS. In a web browser, enter the mDNS name:
http://xw-112.local/
3.1 Main Tab
This is the initial page that is
displayed when accessing the setup
pages. It displays model and serial
number information, and has
navigation tabs which allow access to
the configuration and setup settings.
Page 10
Xytronix Research & Design, Inc.
Summary of Contents for XW-112
Page 1: ......
