Control Bionics NeuroNode 3, User Manual

Page: 29 / 33

PAGE 25 | TROUBLESHOOTING
NeuroNode
3
Power Cycle Guide
In some circumstances it may be necessary to perform a power cycle of the
NeuroNode 3 . In order to do this follow these steps:
1. If applicable, in the NeuroNode Controller Application, select “Disconnect.”
2. Using the provided push pin tool, hold down the Standby button for 5
consecutive seconds until the NeuroNode 3 Signal Indicator shows a solid blue
or green light.
3. After 10 seconds, “Shake-to-Wake” can be used to bring the NeuroNode 3 out
of the Standby mode. Gently shake the NeuroNode 3 and it will transition out of
Standby, allowing the NeuroNode 3 to be connected in the Application.
Optionally, use the provided push pin tool to briefly push the Standby button
on the bottom of the device. The initial launch sequence should begin,
indicating an activated NeuroNode 3 .