***
User must maintain good, clean properly connected connections for proper operation
and to avoid damage to the receiver and void the warranty. It is recommended that you use
a battery disconnect when the unit is not in use as continuous powered wiring will enhance
corrosion of wiring.
OPERATION:
650DC STANDARD TRANSMITTER
Shown above is a typical transmitter for wireless operation of a 12VDC motor. The button
functions are as follows:
1.
Slow speed setting of approximately 1/3rd of full speed of Motor “A” (Conveyor or
Auger Motor).
2.
Slow speed setting of approximately 1/3rd of full speed of Motor “B” (Spinner Motor).
3.
Medium speed setting of approximately 2/3
rd
’s of full speed of Motor “A”.
4.
Medium speed setting of approximately 2/3
rd
’s of full speed of Motor “B”.
5.
Full
speed setting of approximately 3/3
rd
’s of full speed of Motor “A”.
6.
Full speed setting of approximately 3/3
rd
’s of full speed of Motor “B”.
7.
Blast/
A timed 6 to 8 second moderate speed to large motor
8.
OFF/
Shuts down the receiver unit. Must be turned on again using on/off
9.
**** It is recommended that when the DC motor/s is under high loads that the control
first be started at medium to high speed for the first 1 to 5 seconds of operation to avoid
damage to the motor or control and may void the warranty****
