Control4
®
KNX
During a reset the bus line is disconnected from the output voltage and shorted. This restarts devices
connected to this bus line. The red Reset LED lights up for the duration of the reset. The LED goes off
when the reset is complete. A reset takes around 20 seconds.
If the line is to be disconnected from the voltage for an extended period, pull off the bus connection
terminals from the KNX power supply.
Reset via bus connection terminal
Pull off the device's bus connection terminal for approx. 20 seconds.
Summary of Contents for C4-KNX-PS640MA
Page 1: ......
Page 9: ...Control4 KNX 2CDC072013F0013...
Page 16: ...Control4 KNX Notes...
Page 17: ...Control4 KNX...
